Exceed RC 3-Channel J3 Piper Cub EP Electric RC Airplane 100% Ready-to-Fly New THE BEST TRAINER!!!

By Jim Luck, January 3, 2010 12:50 am

Exceed RC 3-Channel J3 Piper Cub EP Electric RC Airplane 100% Ready-to-Fly New THE BEST TRAINER!!!

Exceed RC’s SD J3 Grasshopper Scale RC Plane 1:10 SCALE READY TO FLY Electric Powered RC Airplane, Brand New! Ready to fly RC with amazing performance. Complete with 3 channel C&F RC, 9 gram micro servos, rechargeable battery and charger installed. Even the pushrods and control surface horns are fitted! Factory built. Just takes minutes to assemble. You can even remove the RC and use it in other models! What a great investment in fun!!
Piper Cub J3 Beginners Guide Part 1
‘
Piper Cub J3 Beginners Guide Part 2

RC J3 Piper Cub

The J3 CUB 3 Channel has successfully trained thousands of newbie radio controlled pilots worldwide. You’ll be flying within minutes of receiving this fully built airplane enjoying over 12 minute flight times on a single charge thanks to our new improved NiMH battery and ball bearing gear drive system. Equipped with a powerful speed electric motor, which starts with a push of a button, the J3 CUB is capable of take-offs from the ground with its huge powerful motor and wide wingspan.

RC J3 Piper Cub

Battery Operated 380 Motor Plane
Ready to Fly, assembly can be done in 10 mins
Digital Proportional Speed Controller
Slow Speed Flying Capable, Good for Beginner
Shock Resistant Reinforced Foam Fuselage and Strong Wings
2 X 18g micro servo for Rudder and Elevator Control
R/C Set included, Complete 3 Channel Control including
- Complete Left/Right Control by Rudder
- Complete Elevator Control
- Digital Proportional Motor Speed Control Knob
Superb Quality–Simply The Best RTF Plane you can find
Up to 300Maltitude, over 15 mins flight time
Powered by 8.4V NIMH re-chargeable battery (110v adaptor included)
Can Fly as a Glider (without Motor Power)
Brand NEW
All tools required are included for you
Assembly take less than 20mins
Best Looking Plane on the market

RC J3 Piper Cub

Data Sheet:

Ready to fly (RTF) with battery charger and RC!
Includes REAL RC equipment which can be used in other models!
Wing span - 37.5 inches (95.5cm)
Length - 28.8 inches (73cm)
Wing area - 13.7dm2

RC J3 Piper Cub

Assembly is a snap! With no tools required, you can be up and flying within minutes of opening the box!

Highlighted features for this airplane
	Transmitter3 Channel Radio Controller features: Left/Right Control Elevator Control Digital Progressive Motor Speed Control Knob Newest design Full 3 Channel capability with a variable speed throttle control
	These servos are “Designed to work with almost all Radio Control Systems” Compatiable w/: FUTABA, JR, HITEC, AIRTRONICS, GWS, SANWA & AASHAI Radio Systems
	This Receiver Is Designed To Handle Hitec, Futaba, Airtronics, JR on 27MHz. Whole-digital modulational circuitry, with the function of signal discrimination, is sensitive to receive the signal and strong to resist interference.
	Micro high frequency electronic speed control with the battery eliminator circuitry (BEC). It is designed for electric motors up to a speed 600 in size. It will handle up to an 8 cell battery pack and is rated for a maximum of 22 amps continous current.
	Ni-MH Battery Uses one rechargeable NiMH battery pack (included) and an automatic DC peak battery charger.
	380-Motor